:	Dec 6, 2004

.

Remove the rear overhead console.   Carefully release the 9 clips.   Disconnect the 2 electrical connectors.

.

Remove the roof opening panel module.   Slide the module to the LH side to release it from the bracket.   Disconnect the 2 electrical connectors.

.

Install the roof opening panel module.   Connect the electrical connectors.   Secure the module to the bracket.

.

Install the rear overhead console.   Connect the electrical connectors.   Carefully secure the clips.

.

Using T4, configure a new roof opening panel module.

.

If the battery has been disconnected, the one touch and anti-trap function will become inoperative. Close the roof opening panel and continue to hold the switch for a further 20 seconds to allow the sunroof to complete a full cycle. This will complete the roof opening panels calibration routine and reset these functions.